Given serial access on an mt7981, you can usually use the UART recovery protocol to boot a bricked device entirely over serial, e.g. with https://github.com/981213/mtk_uartboot just run something like
mtk_uartboot -s /dev/ttyS0 -a -p bl2.ram -f fip.img
This is one of the things that makes the filogic routers nice to hack at, the other being that they're arm64 rather than something weird and legacy.
Archive link to save hammering the server https://archive.is/wqWkO
This is a great story. Hopefully it encourages others do the same. I have done a similar thing a few years back for another cheap router that had a new revision.
You can buy a used AX1800 with OpenWrt in China for around five or six euros.... XD
How can I resurrect a router that doesn't boot? I flashed a nightly version of OpenWRT on my TP Link Archer, and I believe it fails on the bootloader stage.
I don't have any JTAG/serial comms but I could get some if that's the best way. Thanks
Usually the bootloader can load a rom using tftp:
https://openwrt.org/docs/guide-user/installation/generic.fla...
You don't need anything except a lan cable. You need to set a static IP to the tftp server machine and name the flashing file properly and it should just work.
Interesting. I did have a working OpenWRT setup initially. I don't recall touching the bootloaders at all and I'm not aware whether they've been set up for the tftp fallback. I'll look into it. Thanks!
> coreboot's "flashrom" doesn't support SPI NAND flashes, neither exists a suitable applet for the Glasgow, and I didn't want to buy an expensive XGecu >>>T56<<< (my TL866II doesn't support them either).
Would the T48 not be sufficient?
Unfortunately it is not clear exactly what flash chip is used. Only thing the T48 doesn't support is OneNAND according to https://www.bulcomp-eng.com/datasheet/XGecu%20T56,%20T48,%20...
[dead]